We always have that one ring that fits perfectly, it’s never too loose neither too tight; it fits just right. Well, that could be any ring if the size is measured accurately.
Step 1: Take a string
Step 2: Measure the ring end-to-end
Step 3: Place it against a ruler to reveal the internal
diameter of your ring
Step 4: Use the table below to see your ring size. If it
falls in the middle of two sizes, pick the larger one
OR
Don’t want to risk it with an older ring? Want to make sure you have a snug fit? Look no further. Just follow these steps to get your right size as per your finger.
Step 1: Take a strip of paper
Step 2: Wrap this around your finger tightly, mark with a pen where the paper meets. The tighter the more accurate your measurement. If the band of the ring you want to buy is thick do not make the paper too tight. Thick rings can feel tighter.
Step 3: Unroll the paper strip and measure with a ruler from the edge to the pen mark. This is your finger’s circumference.
Step 4: Use the table below to see your ring size, if it falls in the middle of two sizes, pick the larger one.
OR
Measure your fingers at the end of the day when they are at their largest
Cold weather can shrink your fingers up to half a size, so make sure they are warm
Avoid measuring your fingers after eating salty food as they tend to swell after
Most of our bracelets have adjustable links at 16cm, 17cm & 18cm so its “one size fits all”. In case you love a bangle and are worried about the fit; just refer to our measurement chart or use the ruler found in our size guide to find the size that suits you.
